Installing MacBook Pro 1 5" Retina Display Mid 201 2 AirPort/Camera Cable
/ffXft
Installing MacBook Pro 15
Retina Display Mid 2012
AirPort/Camera Cable
Written By: Brett Hartt
SUMMARY
Prereq only.
Step 1 — AirPort/Camera Cable
• Use the tip of a spudger to pry the
three AirPort antenna cables
straight up off of their sockets on
the AirPort board.
©iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 3
Installing MacBook Pro 1 5" Retina Display Mid 201 2 AirPort/Camera Cable
Step 2
• Use the tip of a spudger to push
the camera cable connector out of
its socket on the logic board.
• Be sure to push parallel
to the board, pushing first
on one side, then the other to
"walk" the connector out of its
socket.
Step 3
• Insert the flat end of a spudger underneath the rubber heat sink cover on the right fan.
• Slide the spudger underneath the length of the cover, releasing the adhesive.
• Lift the cover and flip it back so that you can access the cables underneath.
©iFixit — CCBY-NC-SA
www.iFixit.com
Page 2 of 3
Installing MacBook Pro 1 5" Retina Display Mid 201 2 AirPort/Camera Cable
Step 4
• Use your fingers to pull the AirPort/Camera cables up off the fan.
♦ The cables are adhered to the fan, so peel them up carefully to prevent ripping
any.
• Carefully de-route the cables from the plastic cable guide.
a
To reassemble your device, follow these instructions in reverse order.
This document was last generated on 2012-10-31 07:54:01 AM.
©iFixit — CCBY-NC-SA
www.iFixit.com
Page 3 of 3
TVNews
OpenLibrary